Installation

Setting the Link Interface Type

(Universal WAN only)

The Universal WAN Interface must be configured to match the service to which it will be connected.

WARNING: ensure that the connector cable used with the Universal interface module has the correct pinouts for the operational mode selected for the interface (V.11/X.21, V.35, RS232/V.24, or RS530/RS422). Using the incorrect cable connector for the operational mode selected may cause permanent damage to the interface module. Please see Appendix D for pinout assignments.

7Set Link Interface Type: Location: Main

ÄConfiguration

ÄWAN Set Up

ÄLink Set Up

ÄLink Interface Type

Select the Service type to which this router will be connected.

Note: If the module is being changed from one type of service to another, you must first select “none” before a new selection may be chosen. Also the link must be toggled through a disable/enable cycle before the change is brought into effect.

11

Page 17
Image 17
Black Box LR1530A-EU-R3, LR1530A-R3 manual Setting the Link Interface Type, Set Link Interface Type Location Main