Installation
Oven Assembly
DOUBLE SECTION ASSEMBLY
1.Place lower section in predetermined place of installation.
2.Attach the legs (and casters if applicable) as previously described.
3.Using two 1” boards, place one near the edge of the oven and the other at the far side of the flue collar.
4.Lift the upper section and place on the boards. Push the top section across until the sections are even.
5.Remove the board from one side by placing a 2” x 4” approximately four feet long under the angle frame. Lift to remove the board.
6.Remove the other board in the same manner as above, allowing the upper section to come gently to rest in the proper position.
7.Install gas
8.Install the canopy or direct type vent as appro- priate.
9.Remove all tags.
10.Level the ovens side to side and front to back by placing a spirit level on the base frame of the lower section and screwing the adjustable leg feet in or out as appropriate.
ULTRA ROKITE DECK
1.Slide the Ultra Rokite shelf through the door opening. Rest the shelf on the deflector and slide to the rear of the oven until it drops into the shelf support.
2.Refer to
NOTE: Because of the weight of the Ultra Rokite shelves, take care to avoid injury to your- self or damage to the shelves when sliding sections into the oven.
NOTE: For model 981, Ultra Rokite is only avail- able as a bottom deck. DO NOT install the Ultra Rokite in the top baking compart- ment of a 981.
Double Section Assembly |
Figure 4
6
