Bosch Appliances Divar -Digital Versatile Recorder Ethernet connection, Network configuration

Divar Installation Manual Hardware setup

EN 4-5

Ethernet connection

The standard RJ-45 Ethernet socket is used to connect the unit directly to a PC or to a network. The Ethernet is also used to connect to an ATM/POS bridge unit. To connect directly to a network hub, use a straight-through network cable. To connect directly to a PC, use the supplied cross-over network cable. Consult with your local IT personnel for the specific type of cable needed. The cable length from node to node is limited to 100 feet (30.5 meters) maximum length and 6 feet (1.8 meters) minimum length.

Network configuration

The Divar is delivered with the DHCP function switched on, so IP addresses are assigned automatically if the network server uses DHCP. (Refer to the System

settings/Connectivity/Network setup menu.)

Specifications

Connection:	10/100 BaseT, IEEE 802.3
Differential signal voltage:	± 2.8V max, inputs have transient overvoltage
	protection.
Port details:	IEEE 802.3/802.3u - 100Base-TX/10Base-T physical
	layer.
	Auto Negotiation: 10/100, Full / Half Duplex
Cable length:	100 Meters: 100 Ohm unshielded twisted pair cable,
	category 3/4/5.
	100 Meters: 150 Ohm shielded twisted pair cable.
Impedance:	In-built compensation for impedance matching.
Indicators:	ACT, 10, 100

LAN - RJ-45 Ethernet socket

Signal Name:	Pin no.	Description
LAN_TX+	1	Ethernet transmit line plus
LAN_TX-	2	Ethernet transmit line minus
LAN_RX+	3	Ethernet Receive line plus
N/C	4	No Connection
N/C	5	No Connection
LAN_RX-	6	Ethernet receive line minus
N/C	7	No Connection
N/C	8	No Connection
		8	1

Panel view

Bosch Security Systems