Changing the Oven Temperature When Using the Probe

Changing the Probe Temperature

The probe temperature is displayed in the center to the left of the cooking mode. It starts at 80 degrees and increases in 5°F increments until the chosen probe tem- perature is reached.

The oven is preheated when the beep signals once.

When the set probe temperature is reached, END appears in display and oven turns off.

1.Touch TEMPERATURE. Oven temp will flash in the display.

2.Turn the knob to desired temperature and press START twice.

1.Touch TEMPERATURE. The oven temperature will flash.

2.Press start and PROBE TEMP will flash.

3.Turn the knob to desired temperature and press START again.

Note: Always remove probe from oven when cooking is complete. The probe symbol will remain in the display until the probe is removed. Do not leave probe attachment in oven during self-clean. Oven will not self-clean with the probe installed in the oven

Operation - Warming Drawer (some models)

This section explains how to operate the warming drawer. See “Getting the Most Out of Your Warming Drawer” on page 30 for guidelines to improve warming drawer results.

About the Warming Drawer

Warming Drawer Specifi- cations

The warming drawer will keep hot, cooked foods at serving temperature. Warming drawer settings are Low, Medium, and High.

1

Parts Key:

2

3

1. Stainless Steel Drawer Interior

2. Gasket

3. Rail Lock

Figure 13: Warming Drawer Parts

Drawer Interior: 25" W x 17" D x 5" H

Dish sizes:

2 -9 x 13" Pyrex 3-quart dishes, side by side.

2 -9 1/2 x 15" Pyrex 4-quart dishes, side by side.

4 -10 1/2" plates, single or stacked

3 -11" plates, single or stacked

English 20

Page 22
Image 22
Bosch Appliances HES7282U Operation Warming Drawer some models, About the Warming Drawer, Warming Drawer Specifi- cations