26
Detergent / Rinse-Agent Dispenser
Fig.
2 
1
Fig.
2
1
Fig.
2
1
Fig.
H
Located on the Inner Door is the Detergent / Rinse Agent Dispenser, Fig.
The Dispenser Housing is one assembly containing three individual components.
Rinse Agent Dispenser.
Detergent Cup.
Steam Vent.
Note: Mechanical operation and removal of the Dispenser is shown in Section 4.
To fill or adjust the Rinse Agent Dispenser, open the Rinse Agent Door by pulling up on the Door Latch.
The Dosage Meter, item 1, is now visible. The Dosage Meter allows you to adjust the amount of Rinse Agent dispensed into the rinse stage of the cycle. The factory setting is three.
There is also an eyepiece, item 2, that provides a visual indication as to the amount of Rinse Agent remaining in the Dispenser.
To the right of the Rinse Agent Dispenser is the Detergent Cup, item 1.
Once detergent has been loaded into the cup, slide the Detergent Door, item 2, closed.
When the door is fully closed press down on the door end to lock it.
A white Locking Lever, item 1, will then extend. Once closed, the detergent door may be released by pressing in on the Locking Lever.
With the Detergent Door closed the Steam Vent is now visible, item 2.
During the drying stage of the cycle, steam is drawn through the vent and collects in a Condensation Tube.
