72 |
|
| H | ||
Diagram 1 |
|
|
|
|
|
|
|
|
|
|
|
FUNCTION | DURATION |
| COMMENTS |
| |
|
|
|
|
|
|
DRAINING | 30 Seconds |
|
|
|
|
|
|
|
|
|
|
AQUA SENSOR CALIBRATION | 65 Seconds |
| Not used on the SHI/U |
| |
|
|
|
|
|
|
FILLING | Until Water Level Switch (f1) |
| This function cannot be bypassed |
|
|
Closes. |
|
| |||
|
|
|
|
| |
|
|
|
|
|
|
HEATING & | Until Water Temperature Reaches |
| Dispenser Actuator Energizes |
|
|
CIRCULATING | 150° f. |
|
| ||
|
|
|
| ||
|
|
|
|
|
|
DRAINING | 60 Seconds |
|
|
|
|
|
|
|
|
|
|
• To bypass a function: SHI/U | Press the SCRUB WASH button |
|
|
| |
SHI/U
SHI/U 43— MODELS
To begin the test program, press the POWER SCRUB PLUS and REGULAR WASH buttons both in at the same time as you turn the unit on by pressing the ON/OFF button. When released the LED’s for the two programs will begin flashing.
To check all LED indicator lamps press the SCRUB WASH button.
To start the test program, press the POWER SCRUB PLUS and REGULAR WASH buttons both in a second time.
When the test program is complete, if a fault is detected the following indicator LED’s will be illuminated.
WASH | = | Heating Fault |
RINSE/DRY | = | Filling Fault |
CLEAN | = | NTC Fault |
SHU 53— or SHI/U 68— MODELS
To begin the test program, press the SCRUB WASH and DELICATE/ECONO buttons both in at the same time as you turn the unit on by pressing the ON/OFF button. The version number of the circuit board will appear in the display, 20, 21, etc.
When released the LED’s for the two programs will begin flashing.
The check each LED press the corresponding program button. To check the countdown display and refill rinse aid LED press the REGULAR WASH button.
To start the test program, press the SCRUB WASH and DELICATE/ECONO buttons both in a second time.
When the test program is complete, the countdown display will indicate a fault or combination of faults using the following codes. If a combination of faults exists, the code numbers are added together. (6 = faults 2 + 4).
0 = No Faults
1 = Aqua Sensor Fault
2 = Heating Fault
4 = Filling Fault
8 = NTC Fault
