94Print Modes and Options Print Modes

Caution • While performing any tasks near an open printhead, remove all rings, watches, hanging necklaces, identification badges, or other metallic objects that could touch the printhead. You are not required to turn off the printer power when working near an open printhead, but Brady recommends it as a precaution. If you turn off the power, you will lose all temporary settings, such as label formats, and you must reload them before you resume printing.

To set up the printer in Peel-Off mode, complete these steps:

1.Remove the rewind plate (if installed) from the front of the printer. Store it on the two mounting screws on the inside of the control panel. See Figure 31, Rewind Plate,

on page 119 for more information.

2.Set the printer to Peel-Off mode. See Select Print Mode on page 65 for instructions.

3.Insert media into the printer. See Prepare the Media for Loading on page 32 for instructions.

4.Open the printhead assembly by rotating the printhead-open lever (1) counter-clockwise.

1

5.Loosen the thumb screw (not visible from this angle) that is located on the bottom of the outer media guide (1).

1

14068L-001 Rev. A

X-Plus II User Guide

1/11/07