Brady X-Plus II Table 20 • Applicator Interface Connector Pin Configuration (Continued)

Data Ports 171

Applicator Interface Connector

Table 20 • Applicator Interface Connector Pin Configuration (Continued)

Pin	Signal Name	Signal Type	Description
No.
6	REPRINT	Input	• If the Reprint feature is enabled, this input must be
			asserted LOW to cause the printer to reprint the last
			label.
			• If the Reprint feature is disabled, this input is ignored.
7	+28 V	Power	The Interface Power Supply. Supplies power to external
	(Fused at 500 mA.)		sensors as required.
	Caution • Replace		Note • If operating with 28V signals only, pin 7
	the fuse only with		may be used to supply power to pin 2, which
	one of the same		creates a non-isolated mode of operation.
	type and rating.
8	POWER GROUND	Ground	The Interface Power Ground.
	(+28 V DC Return)		Note • If pin 7 is used to supply power to pin 2,
			use this pin to ground pin 1.
9
10	SERVICE	Output	Asserted LOW in the following circumstances:
	REQUIRED		• the media cover is open
			• the printhead is open
			• the ribbon or media is out
			• the printer is paused
			• an operational fault occurs
			• a Resynch error occurs while the applicator Resynch
			mode is set to Error mode
11	END PRINT	Output	• MODE 0—The applicator port is OFF.
			• MODE 1—Asserted LOW only while the printer is
			moving the label forward; otherwise deasserted HIGH.
			• MODE 2—Asserted HIGH only while the printer is
			moving the label forward; otherwise deasserted LOW.
			• MODE 3—(Default) Asserted LOW for 20
			milliseconds when a label is completed and positioned.
			Not asserted during continuous printing.
			• MODE 4—Asserted HIGH for 20 milliseconds when a
			label is completed and positioned. Not asserted during
			continuous printing.
12	MEDIA OUT	Output	Asserted LOW while there is no media in the printer.

1/11/07 T408M/T408M-R User Guide 14178L-001 Rev. A