Print Modes and Options 113

Print Modes

Caution • While performing any tasks near an open printhead, remove all rings, watches, hanging necklaces, identification badges, or other metallic objects that could touch the printhead. You are not required to turn off the printer power when working near an open printhead, but Brady recommends it as a precaution. If you turn off the power, you will lose all temporary settings, such as label formats, and you must reload them before you resume printing.

To set up the Rewind mode for printers with the cutter option, complete these steps:

1.If you have not already done so, install the rewind plate. See Install the Rewind Plate on page 119 for instructions.

2.Set the printer to Rewind mode. See Select Print Mode on page 65 for instructions.

3.Insert media into the printer. See Prepare the Media for Loading on page 32 for instructions.

4.Open the printhead assembly by rotating the printhead-open lever (1) counter-clockwise.

1

5.Loosen the thumb screw (not visible from this angle) that is located on the bottom of the outer media guide (1).

1

1/11/07

X-Plus II User Guide

14068L-001 Rev. A