142Troubleshooting LCD Error Messages

Table 11 • LCD Error Messages (Continued)

 

LCD Display/

Possible Cause

Recommended Solution

 

Printer Condition

 

 

 

 

 

 

 

 

 

 

 

Caution • The cutter blade is sharp. Do not touch or rub the blade

 

ERROR CONDITION

 

 

 

with your fingers.

 

 

CUTTER JAM

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The printer stops; the

Cutter blade is in the media path.

Turn off the print engine power and

 

 

unplug the printer. Inspect the cutter

 

ERROR light flashes.

 

module for debris and clean as needed

 

 

 

 

following the cleaning instructions in

 

 

 

 

Clean the Cutter on page 133.

 

 

 

 

 

 

 

 

There is not enough memory to

Free up some of the printer’s memory

 

OUT OF MEMORY

 

 

 

perform the function specified on

by adjusting the label format or printer

 

(function)

 

the second line of the error

parameters. One way to free up

 

 

 

message.

memory is to adjust the print width to

 

 

 

 

the actual width of the label instead of

 

 

 

 

leaving the print width set to the

 

 

 

 

default. See Set Print Width

 

 

 

 

on page 67.

 

 

 

 

 

 

 

 

 

Ensure that the device, such as FLASH

 

 

 

 

memory or PCMCIA card, is installed

 

 

 

 

and not write protected or full.

 

 

 

 

 

 

 

 

 

Ensure that the data is not directed to a

 

 

 

 

device that is not installed or is

 

 

 

 

unavailable.

 

 

 

 

 

 

 

 

 

Call a service technician.

 

 

 

 

 

14068L-001 Rev. A

X-Plus II User Guide

1/11/07