OPERATING YOUR Juice Fountain™ Plus

1.Wash your selection of fruit and vegetables ready for juicing.

NOTE:

Most fruit and vegetables such as apples,carrots and cucumbers will not need to be cut to size as these will fit into the feed chute whole.

When juicing carrots place the tip of the carrot into the feed chute last.

2.Ensure the Juice Fountain is correctly assembled. Ensure the stainless steel filter is thoroughly cleaned before each use (refer to care and cleaning on page 21). Ensure you place the juice jug (or a glass)under the spout before commencing juicing.

3.Plug the power cord into a 110/120V power outlet. Push the two speed switch either up for low speed or down for high speed depending on the type of fruit or vegetable being juiced. Use the speed selector table as a guide for juicing different fruits and vegetables.

NOTE:

Be sure to start the motor first before placing any fruits or vegetables down the feed chute. Failure to start the motor prior, can cause the motor to overheat.

!WHEN USING THE JUICE FOUNTAIN ON HIGH SPEED,DO NOT RUN THE JUICER FOR LONGER THAN 4 MINUTES AT A TIME WHEN CONTINUOUSLY JUICING HARD FRUITS AND VEGETABLES, SUCH AS APPLES,CARROTS,AND BEET. AFTER SUCH TIME, WAIT 1 MINUTE BEFORE RESUMING FEEDING FRUITS AND VEGETABLES DOWN THE FEED CHUTE.

15

JE98XL_IB_Issue1,09.indd 15

16/12/09 11:26 AM

Page 15
Image 15
Breville JE98XL manual Operating Your Juice Fountain Plus