Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 691
53-1001931-01
Wireless configuration commands 20
nac-server
[primary|secondary|
timeout]
Configure a NAC server IP address and an optional authentication
port number.
•[primary|secondary] [<IP> {auth-port <port>}|radius-key [0
<secret>|2 <secret>|<secret>]] – Primary server or
secondary server’s IP address
•<IP> {auth-port <port>} – Set an EAP server IP address
and optional EAP server authentication port (defau lt: is
1812)
•radius-key [0 <secret>|2 <secret>|<secret>] – Create
a Radius server shared secret, up to 127 characters
•0 <secret> – Password is specified as
unencrypted
•2 <secret> – Password is encrypted with
password-encryption secret
•<secret> – Configures a NAC server shared secret
•timeout <1-300> retransmit <1-100> – Sets the time the
controller waits for a response from the RADIUS server
before retrying. This is a global setting for both the primary
and secondary servers.
•retransmit <1-100> – Number of retries before the
wireless controller will give up and disassociate wireless
client
•<1-100> – Retry count
NOTE: The RFController(config-wireless)# nac-server timeout<*>
retransmit<*> should be less than what is defined for an
Client’s timeout and retries. If the Client’s time is less than
the server’s, a fallback to the secondary server will not
work.
nas-id <nas-id> The nas-id of this wlan to be sent to the RADIUS server. Maximum
length of 256 characters.
nas-port-id <port> The nas-port-od of this wlan to be sent to the RADIUS server.
Maximum length of 256 characters.
qos
[classification |
mcast-with-dot11i|
mcast1|mcast2|
prioritize-voice|
rate-limit|svp|weight|
wmm]
Quality of Service commands.
•classification [background|best-effort|video|voice|wmm] –
Select how traffic on this WLAN is classified (relative
prioritization on the access point).
•low – All traffic on this wlan is treated as low priority
traffic (Background).
•normal – All traffic on this wlan is treated with normal
priority (Best Effort).
•video – All traffic on this wlan is treated as Video.
•voice – All traffic on this wlan is treated as Voice.
•wmm – Use WMM based classification, using DSCP or
802.1p tags to classify traffic into different queues.
•mcast-with-dot11i enable – Enables multicast mask with
dot11i.
•[mcast1|mcast2] <MAC> – Sets multicast masks.
•mcast1 <MAC> – Sets multicast mask for egress
prioritization.
•mcast2 <MAC> – Sets multicast mask for egress
prioritization.
•<MAC> – MAC address.
•prioritize-voice – Prioritize voice frames over general data
frames (applies to non-WMM wireless-client).