Brother 882-S90/S91 manual Spool cap small Thread spool cross-wound thread Space

LOWER THREADING

CAUTION

•If the thread spool and/or spool cap are set incorrectly, the thread may tangle on the spool pin and cause the needle to break.

•Use the spool cap (large, medium, or small) that is closest in size to the thread spool. If a spool cap smaller than the thread spool is used, the thread may become caught in the slit on the end of the spool and cause the needle to break.

Memo

When sewing with fine, cross-wound thread, use the small spool cap, and leave a small space between the cap and the thread spool.

c b

a

aSpool cap (small)

bThread spool (cross-wound thread)

cSpace

eWith your right hand, hold the thread near the thread spool. With your left hand, hold the end of the thread, and use both hands to pass the thread through the thread guide.

a

aThread guide

fPass the thread under the pin, and pass the thread around the pretension disk making sure that the thread is under the pretension disk.

a

b

aPin

bPretension disk

gWind the thread clockwise around the bobbin 4-5 times.

2

31

hPass the end of the thread through the guide slit in the bobbin winder seat, and pull the thread to the right to cut the thread with the cutter.

b

a

aGuide slit

bBobbin winder seat

CAUTION

•Be sure to follow the process described. If the thread is not cut with the cutter, and the bobbin is wound, when the thread runs low it may tangle around the bobbin and cause the needle to break.

20