Brother 882-S90/S91 manual Using the Spool Pin

iSet the bobbin holder to the left, until it clicks into place.

a

aBobbin holder (switch)

Memo

When the bobbin holder is set to the left, it works as a switch to make the bobbin wind automatically.

→The bobbin starts winding automatically and stops rotating when it is done winding. The bobbin holder will return to the original position.

jCutthe bobbin.the thread with the cutter and remove

Memo

•When removing the bobbin, do not pull on the bobbin winder seat. Doing so could loosen or remove the bobbin winder seat, and could result in damage to the machine.

CAUTION

•Setting the bobbin improperly may cause the thread tension to loosen, breaking the needle and possibly resulting in injury.

a b

LOWER THREADING

■Using the Spool Pin

You can use the main spool pin to wind the bobbin before sewing. You cannot use this spool pin to wind the bobbin while sewing.

6

7

2

5		8
	4	3

l o

1

aTurn the main power to ON.

bAlign the groove in the bobbin with the spring on the bobbin winder shaft, and set the bobbin on the shaft.

a

b

aGroove of the bobbin

bSpring on the shaft

cPivot the spool pin so that it angles upward. Set the thread spool on the spool pin so that the thread unwinds from the front of the spool.

a

b c

aSpool pin

bSpool cap

cThread spool

1

Getting Ready

21