Brother 882-S90/S91 manual Overcasting Using the Side Cutter

SEWING THE STITCHES

■Overcasting Using the Side Cutter

By using the side cutter, you can do overcasting while cutting the fabric.

CAUTION

•Make sure to only select one of the stitches listed below. Using another stitch may cause the needle to hit the presser foot and break, possibly causing injury.

Memo

Thread the needle manually when using the side cutter, or only attach the side cutter after threading the needle using the “Automatic Threading” button.

		Presser		Stitch width		Stitch length		Twin
Stitch	Stitch name		Applications	[mm (inch.)]		[mm (inch.)]
		foot						needle
				Auto.	Manual	Auto.	Manual
	With side cutter		Straight stitch while cutting	0.0	0.0 - 2.5	2.5	0.2 - 5.0
			fabrics					NO
				(0)	(0 - 3/32)	(3/32)	(1/64 - 3/16)
	With side cutter		Zigzag stitch while cutting fabrics	3.5	3.5 - 5.0	1.4	0.0 - 4.0
								NO
				(1/8)	(1/8 - 3/16)	(1/16)	(0 - 3/16)
	With side cutter		Overcasting stitch while cutting	3.5	3.5 - 5.0	2.0	1.0 - 4.0
			fabrics					NO
				(1/8)	(1/8 - 3/16)	(1/16)	(1/16 - 3/16)
	With side cutter		Overcasting stitch while cutting	5.0	3.5 - 5.0	2.5	1.0 - 4.0
			fabrics					NO
				(3/16)	(1/8 - 3/16)	(3/32)	(1/16 - 3/16)
	With side cutter		Overcasting stitch while cutting	5.0	3.5 - 5.0	2.5	1.0 - 4.0
			fabrics					NO
				(3/16)	(1/8 - 3/16)	(3/32)	(1/16 - 3/16)

3

Utility Stitches

aFollow the steps on page 32 to remove the presser foot.

bPosition the fork on the side cutter’s operating lever onto the needle clamp screw.

b

a

aNeedle clamp screw

bOperating lever

Memo

Make sure that the fork of the operating lever is set onto the needle screw firmly.

cPosition the side cutter so that the side cutter pin is aligned with the notch in the presser foot holder, and then lower the presser foot.

b a

aNotch in presser foot holder

bPin

→The side cutter is attached.

65