Brother 882-S90/S91 manual Sewing Stretch Fabrics, Lower the presser foot and start sewing

SEWING THE STITCHES

Memo

For keyhole buttonholes, use the eyelet punch to make a hole in the rounded end of the but- tonhole. Then insert a pin along the inside of one of the bar tacks, insert a seam ripper into the hole made with the eyelet punch, and cut towards the pin.

b

a

aEyelet punch

bBasting pin

■Sewing Stretch Fabrics

When sewing on stretch fabric with or , sew the buttonhole stitches over a gimp thread.

aHook the gimp thread onto the back of presser foot “A”. Insert the ends into the grooves at the front of the presser foot, and then temporarily tie them there.

a

a Upper thread

bLower the presser foot and start sewing.

Memo

Set the width of the satin stitches to the width of the gimp thread, and set the buttonhole width to be 2-3 times the width of the gimp thread.

cOnce sewing is completed, gently pull the gimp thread to remove any slack, and trim off any excess.

Memo

After using the seam ripper to cut open the threads over the buttonhole, trim off the threads.

■Odd Shaped Buttons/Buttons that do not Fit into the Button Holder Plate

Use the markings on the presser foot scale to set the size of the buttonhole. One mark on the presser foot scale equals 5 mm (approx. 3/16 inch).

Add the button diameter and thickness together, and then set the plate at the calculated value.

b

a

c

d

aPresser foot scale

bButton holder plate

cCompleted measurement of diameter + thickness

d5 mm (approx. 3/16 inch)

Memo

For example, for a button with a diameter of 15 mm (approx. 9/16 inch) and a thickness of 10 mm (approx. 3/8 inch), the scale should be set at 25 mm (approx. 1 inch).

a

b

a10 mm (approx. 3/8 inch)

b15 mm (approx. 9/16 inch)

3

Utility Stitches

83