Brother 882-S90/S91 manual Flat Fell Seam, Spread the fabric out along the finish line

SEWING THE STITCHES

dSew two rows of straight stitches parallel to the seam line, then trim excess thread leaving 50 mm (approx. 1-15/16 inches).

b	a
	c

aSeam line

b10 to 15 mm (approx. 3/8 inch to 9/16 inch)

cAbout 50 mm (approx. 1-15/16 inches)

ePull the bobbin threads to obtain the desired amount of gather, then tie the threads.

fSmooth the gathers by ironing them.

gSew on the seam line and remove the basting stitch.

Flat Fell Seam

Use for reinforcing seams and finishing edges neatly.

aSelect and attach presser foot “J”.

bSew the finish line, then cut half of the seam allowance from the side on which the flat fell seam will lie.

*When the automatic thread cutting and automatic reinforcement stitching are preset, reinforcement stitches will be sewn automatically at the beginning of sewing. Press the “Reverse/Reinforcement Stitch” button to sew a reinforcement stitch and trim the thread automatically at the end of sewing.

a

b

aAbout 12 mm (approx. 1/2 inch)

bWrong side

cSpread the fabric out along the finish line.

b

a

aFinish line

bWrong side

dLay both seam allowances on the side of the shorter seam (cut seam) and iron them.

a

aWrong side

58