Brother 882-S90/S91 manual Pull the thread under the thread path guide

UPPER THREADING

fPush the spool cap onto the spool pin as far as possible, then return the spool pin to its original position.

CAUTION

•If the thread spool and/or spool cap are set incorrectly, the thread may tangle on the spool pin and cause the needle to break.

•Use the spool cap (large, medium, or small) that is closest in size to the thread spool. If a spool cap smaller than the thread spool is used, the thread may become caught in the slit on the end of the spool and cause the needle to break.

gHolding the thread with both hands, slide the thread into the grooves on the thread guide plate.

a

aThread guide plate

hWhile holding the thread in your right hand, use your left hand to pull the thread toward the threading path cover, then pass it along the thread path as shown in the illustration.

Be sure to pass the thread along the right side of the thread path guide.

1a

b

aThreading path cover

bThread path guide

iPull the thread under the thread path guide.

a

(A)a

aThread path guide

jPull back up the thread along the left side of the thread path guide to the top left corner of the threading path cover.

a

b

aTop left corner

bThreading path cover

kPull the thread back down to the needle bar along the left side of the thread path guide.

*Make sure the thread is hooked at the top corner and positioned behind the transparent front cover.

a

(C)b

aThread take-up lever check window

bTransparent front cover

Memo	a
	b
a Take-up lever	b Thread

Look through the thread take-up lever check window and check that the thread is correctly fed through the take-up lever, turning the handwheel toward you.

28