
5. USING THE OPERATION PANEL (BASIC OPERATIONS)
4 | Select the item to be changed. | Press the SELECT key. |
| ||
|
|
|
|
| 2401B |
|
|
| The selected parameter changes in the order shown in | ||
|
|
| the illustration below each time the SELECT key is | ||
|
|
| pressed. |
|
|
| Pattern | ||||
|
|
|
|
| |
5 | Change the setting for the parameter. |
|
|
| |
| (Refer to “List of parameters” on the next page for details | Press the | or | key to change the parameter | |
| on parameter changes. |
| setting. |
|
|
|
|
|
|
| |
|
|
|
|
| 2382B 2383B |
|
|
| The flashing display means that the parameter setting | ||
|
|
| has not yet been applied. | ||
|
|
| You can make the initial setting appear in the display | ||
|
|
| by pressing the RESET key. | ||
|
| 2402B |
|
|
|
|
|
|
| ||
6 | Apply the changed parameter setting. | Press the ENTER key. |
| ||
|
|
| The display will change from flashing to illuminated, | ||
|
|
| and this means that the setting has been applied. | ||
|
|
| If you press the SELECT key or the TEST key without | ||
|
|
| pressing the ENTER key, you can cancel the | ||
|
|
| parameter changes. |
| |
|
| 2403B |
|
|
|
|
|
|
| ||
7 | Repeat steps 4 to 6 above to record the settings for each parameter. |
|
| ||
|
| ||||
8 | If you would like to continue setting another program, repeat steps 2 to 7 above. | ||||
|
|
|
|
| |
9 | Exit program mode. |
| Press the TEST key. |
| |
| 2404B | TEST indicator switches off | The display will return to the normal display. | ||
|
|
|
|
37 |