10. TABLE OF ERROR CODES￿

10. TABLE OF ERROR CODES

DANGER

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before opening the face plate of the control box. Touching areas where high voltages are present can result in severe injury.

If a malfunction should occur with the sewing machine, a buzzer will sound and an error code will appear in the display window. Follow the remedy procedure to eliminate the cause of the problem.

Warnings displayed as symbols

Code

 

Cause and remedy

CLdn

The sewing machine started when the work clamp/button clamp was not lowered.

First lower the work clamp/button clamp.

 

UP

The needle bar is not in the needle up stop position.

Turn the pulley until this error display disappears.

 

Switch-related errors

 

Code

 

Cause and remedy

E010

The STOP switch was pressed.

Press the RESET key to clear the error.

 

E011

The STOP switch was pressed.

Press the RESET key to clear the error.

 

You can press the

key to move the work clamp so that you can continue sewing.

E012

The STOP switch was pressed.

Press the RESET key to clear the error, and then depress the foot switch to the 2nd step to carry out home

 

position detection.

 

 

The STOP switch was still being pressed when the power was turned on, or there is a problem with the STOP

E015

switch connection.

 

 

Turn off the power, and then check that connector P9 on the main P.C. board is properly connected.

E016

Problem with the STOP switch connection when the power was turned on.

Turn off the power, and then check that connector P9 on the main P.C. board is properly connected.

 

 

The foot switch was depressed to the 2nd step when the power was turned on.

E025

(Start switch for a two-pedal foot switch).

 

Turn off the power and check the foot switch.

E035

The foot switch was depressed to the 1st step when the power was turned on.

(Work clamp switch for a two-pedal foot switch).

 

Turn off the power and check the foot switch.

E050

Machine head tilting was detected after the power was turned on.

Turn off the power, and then return the machine head to its original position.

 

Check that connector P14 on the main P.C. board is properly connected.

E051

Machine head tilting was detected while the sewing machine was operating.

Turn off the power, and then check that connector P14 on the main P.C. board is properly connected.

 

E055

Machine head tilting was detected when the power was turned on.

Turn off the power, and then return the machine head to its original position.

 

Check that connector P14 on the main P.C. board is properly connected.

E065

An operation panel key was still being pressed when the power was turned on, or key is faulty.

Turn off the power and check the operation panel.

 

KE-430F, BE-438F

72