10.TABLE OF ERROR CODES
Data
Code | Cause and remedy | |
| The enlargement ratio setting caused the sewing data to extend outside the sewing area. | |
E500 | Press the RESET key to clear the error. | |
| Set the enlargement ratio again. | |
E502 | The enlargement ratio caused the data pitch to exceed the maximum pitch of 12.7 mm. | |
Press the RESET key to clear the error. | ||
| Set the enlargement ratio again. | |
E510 | Error in pattern data. | |
Press the RESET key to clear the error. | ||
| ||
| No end code has been input into pattern data. | |
E511 | Press the RESET key to clear the error. | |
| Recreate the pattern data containing the end code, or change the pattern number being read. | |
E512 | Number of stitches exceeds allowed maximum. | |
Press the RESET key to clear the error. | ||
| Change the number of the pattern being read. | |
| Memory switch file cannot be read correctly. | |
E581 | Copy source model and copy destination model are incorrect. (Maybe the 430F is attempting to read data for the | |
438F.) | ||
| Press the RESET key to clear the error. | |
| Read data for the same sewing machine model. | |
E582 | Memory switch versions do not match. | |
Press the RESET key to clear the error. | ||
| Read data for the same version. | |
E583 | Parameter versions do not match. | |
Press the RESET key to clear the error. | ||
| Read data for the same version. | |
Code | Cause and remedy | |
| Thread nipper motor home position cannot be detected. Problem with thread nipper motor or poor thread nipper | |
E690 | encoder connection. | |
Turn off the power, and then clean underneath the needle plate to remove any dust and thread scraps. | ||
| ||
| Check that connector P20 on the main P.C. board is properly connected. | |
| Thread nipper retract position error. | |
E691 | Check if the upper thread trailing length is too long. | |
Turn off the power, and then clean underneath the needle plate to remove any dust and thread scraps. | ||
| ||
| Check that connectors P20 and P4 on the main P.C. board are properly connected. | |
P.C. | ||
Code | Cause and remedy | |
E700 | Abnormal rise in power supply voltage. | |
Turn off the power and check the input voltage. | ||
| ||
E701 | Abnormal rise in sewing machine motor drive voltage. | |
Turn off the power, and then check the voltage. | ||
| ||
E705 | Abnormal drop in power supply voltage. | |
Turn off the power and check the input voltage. | ||
| ||
E710 | Abnormal current detected in sewing machine motor. | |
Turn off the power, and then check if there are any problems with the sewing machine. | ||
| ||
E711 | Abnormal current detected in pulse motor. | |
Turn off the power, and then check if there are any problems with the work clamp/button clamp operation. | ||
| ||
If an error code that is not listed above appears or if carrying out the specified remedy does not solve the problem, contact the place of purchase.
75 |