Brother MFC-6650MC, MFC-7750 manual Dual Access, Real Time Transmission, Real Time TX

56 C H A P T E R S I X

Dual Access

You can scan up to 50 documents into the fax memory, even while the MFC is receiving or sending another fax (from memory). You can set temporary settings for each fax you're scanning, except Timer and Polling.

If you try to scan in and store a 51st fax, the MFC will send it immediately, without storing it in memory.

If you get a MEMORY FULL message while scanning the first page of a fax, press Stop to cancel scanning. If you get a MEMORY FULL message while scanning in a subsequent page, you'll have the option to press Start to transmit the pages scanned so far, or to press Stop to cancel the operation.

1Make sure the document feeder is empty.

2Place the document in the feeder.

3Enter the fax number.

4Press Start . The MFC starts scanning the document and the screen displays the job number (#XX) of the fax and how much memory is available. Then the MFC starts dialing. You can immediately repeat steps 1 through 4 for the next fax.

Your MFC normally operates in Dual Access mode. However, you can override Dual Access by using Real Time Transmission.

Real Time Transmission

When Memory is full, the MFC cannot continue to scan documents into memory before sending. However, you can turn on REAL TIME TX; place the documents in the feeder and enter the fax number. As soon as the phone line is free, the MFC starts dialing and sending the fax.

1Place the document in the feeder.

2Press Function , 1 , 3 , 9 .

The screen displays

9.REAL TIME TX

3 Press Set .