SETUP SEND 6 - 7
Manual and automatic fax Redial
If you are sending a fax manua lly and the line is busy, press
Redial/Pause, and then press Start to try agai n. If you want to
make a second call to the last number dialled, you can save time by
pressing Redial/Pause and Start.
Redial/Pause only works if you dialled from the co ntrol panel.
If you are sending a fax automatically and the line is busy, the MFC
will automatically redial up to three times at five minute s intervals.
Dual Access
You can dial a number, and begi n scanning the fax into memory—
even when the MFC is receiving, sending or printing a fax from
memory. The LCD shows the new job number.
1
If it is not illuminated i n green, press (Fax). Place the
original document face down in the ADF.
2
Enter the fax number.
3
Press Start to send the fax.
The MFC starts scanning the f irst page and the LCD shows the
job number (#XXX) o f the fax. You can repeat Steps 1 to 3 f or
the next fax.
If you get an Out of Memory message while scanning the first
page of a fax, press Stop/Exit to cancel scanning. If you get an
Out of Memory message whil e scanning a subsequent page,
you can press Start to send the pages scanned so far, or press
Stop/Exit to cancel the operation.