2. INSTALLATION
2. INSTALLATION
CAUTION
Machine installation should only be carried out by a | Secure the table so that it will not move when tilting | |
qualified technician. | back the machine head. If the table moves, it may | |
Contact your Brother dealer or a qualified electrician | crush your feet or cause other injuries. | |
| ||
for any electrical work that may need to be done. | Use both hands to hold the machine head when | |
The sewing machine weighs approximately 32 kg | tilting it back or returning it to its original position. If | |
only one hand is used, the weight of the machine | ||
(70lb). The installation should be carried out by two | ||
head may cause your hand to slip, and your hand | ||
or more people. | ||
may get caught. | ||
Do not connect the power cord until installation is | ||
| ||
complete. The machine may operate if the treadle is |
| |
depressed by mistake, which could result in injury. |
|
About the machine set-up location
・Do not set up this sewing machine near other equipment such as televisions, radios or cordless telephones, otherwise such equipment may be affected by electronic interference from the sewing machine.
・The sewing machine should be plugged directly into an AC wall outlet. Operation problems may result if extension cords are used.
0475D
Carrying the machine
・The sewing machine should be carried by the arm and the motor cover by two people as shown in the illustration.
*Do not hold by any part other than the motor cover. If this is not observed, it may result in damage to the sewing machine.
0476D
Tilting back the machine head
・Hold section (A) with your foot so that the table does not move, and then push the arm with both hands to tilt back the machine head.
2101B
Returning the machine head to the upright position
1.Clear away any tools, etc. which may be near the table holes.
2.While holding the face plate with your left hand, gently return the machine head to the upright position with your right hand.
2089M
2 |