4. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
4-3-3. Needle replacement counter
<Setting the needle replacement counter initial value>
1 Press the SEL key so that the COUNT indicator is illuminated.
・ The lower thread counter value will appear in the four columns of the display.
|
| 0509D |
|
|
|
2 | When the FUNC key is pressed two times, the needle replacement |
|
counter display will appear. | ・ The needle replacement counter value will | |
|
| appear in the four columns of the display. |
| (Press two times.) |
| 0514D | |
|
|
|
| |
|
|
|
| |
3 | Press the ENTER key for 2 seconds or more, and then press the |
|
| |
C | or D key to set the initial value. | ・ When the D | key is pressed, the setting | |
|
|
| increases by 1. |
|
|
|
| When the C key is pressed, the setting | |
|
|
| decreases by 1. |
|
|
|
| NOTE: |
|
|
|
| ・ The setting range is from 0 to 9999. | |
|
|
| ・ If an initial value of “0” is set, the needle | |
|
|
| replacement counter will not operate. | |
| (Press for 2 seconds or more.) |
| 0515D | |
|
|
|
| |
<Needle replacement counter operation>
・The needle replacement counter is reduced by 1 from the initial setting value each time the sewing machine sews 100 stitches, and a warning is given when the counter goes below“0”.
When the warning occurs, the COUNT indicator and the ABCD indicator flash, and a buzzer sounds for 5 seconds.
0516D
・Sewing will be possible even after the treadle is returned to the neutral position and the sewing machine stops. However, after the treadle has been depressed backward and thread trimming has been carried out, sewing using the treadle will no longer be possible.
If the treadle is depressed at this time, “Ent” will appear in the display.
When the treadle is returned to the neutral position, the display will return to the current counter display.
・If the ENTER key is pressed while the needle replacement counter is displayed, the COUNT indicator and the ABCD indicator will change to illuminated and sewing can then be carried out using the treadle.
If the ENTER key is pressed again for 2 seconds or more, the counter display will return to the initial value and counting from the initial value will be possible.
20 |