2. INSTALLATION

2-4. Connecting the cords

CAUTION

Contact your Brother dealer or a qualified electrician for any electrical work that may need to be done.

Do not connect the power cord until all cords have been connected.

The machine may operate if the treadle is depressed by mistake, which could result in injury.

When securing the cords, do not bend the cords excessively or fasten them too hard with staples, otherwise there is the danger that fire or electric shocks could occur.

Be sure to connect the ground. If the ground connection is not secure, you run a high risk of receiving a serious electric shock, and problems with correct operation may also occur.

2-4-1. Connecting the cords

0586D

Align the flat edges

Lower the tab (6).

Push in securely until the tabs (6) engage.

1. Cords

(1)8-pin operation panel connector

(2)10-pin resolver connector

(3)12-pin solenoid connector

(4)4-pin motor connector

(5)3-pin power supply connector

Ground symbol

Green and yellow wire (ground wire)

2.Ground wire

(1)Ground wire

(2)Screw

(3)Power cord

1.Attach an appropriate plug to the power cord (3). (The green and yellow wire is the ground wire.)

2.Insert the power plug into a properly-grounded electrical outlet.

NOTE:

For Europe specifications, Americas 220 V specifications and 100 V/400 V system specifications, refer to “2-4-2. Other cords”.

0587D

7

S-7000DD