Brother S-7000DD 0481D 5. Knee lifter plate

2. INSTALLATION

0481D 5. Knee lifter plate

<Knee lifter adjustment>

1. Turn the machine pulley so that the feed dog is below the top of the needle plate.

2. Lower the presser foot (1) by using the lifting lever (2).

3. Loosen the nut (3).

4. Turn the screw (5) to adjust so that the amount of play in the knee lifter is approximately 2 mm when the knee lifter plate (4) is gently pressed.

5. Securely tighten the nut (3).

6. Loosen the nut (6).

7. Turn the adjusting screw (8) to adjust so that the presser foot (7) is at the desired position within a distance of 13 mm of the needle plate when the knee liter plate is fully pressed.

8. After adjustment is completed, securely tighten the nut

(6).

Within 13 mm

0482D

5

S-7000DD

Contents

INSTRUCTION MANUAL Page [1] Safety indications and their meanings Indications Symbols [2] Notes on safety Environmental requirements Installation Sewing Cleaning Maintenance and inspection [3] Warning labels Page 1. MACHINE SPECIFICATIONS 2. INSTALLATION 3. USING THE OPERATION PANEL (BASIC OPERATIONS) 4. USING THE OPERATION PANEL (ADVANCED OPERATIONS) 5. CLEANING Page 1. MACHINE SPECIFICATIONS 2. INSTALLATION About the machine set-uplocation Carrying the machine Tilting back the machine head Returning the machine head to the upright position 2-1.Table processing diagram 2-2.Installation 1. Control box + Oil pan 2. Connecting rod 3. Rubber cushions 4. Machine head 0481D 5. Knee lifter plate 2-3.Lubrication 2-4.Connecting the cords 2-4-1.Connecting the cords 1. Cords 2.Ground wire 2-4-2.Other cords Page Page Page 3.USING THE OPERATION PANEL (BASIC OPERATIONS) 3-1.Names and functions Page 3-2.Sewing start and end backtack stitches 3-3.Sewing continuous backtack stitches 4-1.Switching the 4-columndisplay 4-2.Setting the sewing speed 4-2-1.Setting the maximum sewing speed 4-2-2.Setting the start backtack sewing speed 4-3.Setting the counters 4-3-1.Lower thread counter 4-3-2.Thread trimming counter 4-3-3.Needle replacement counter 4-4.Setting basic functions 4-4-1.Changing the needle stop position 4-4-2.Correction sewing 4-4-3.Setting thread wiping 4-5.Adjusting the needle up stop position 4-6.Resetting all settings to their defaults 5. CLEANING 6. REPLACING THE FIXED KNIFE AND MOVABLE KNIFE 7. STANDARD ADJUSTMENTS 7-1.Adjusting arm thread guide R 7-2.Adjusting the presser foot height 7-3. Adjusting of the feed dog height 7-4.Adjusting the feed dog angle 7-5.Adjusting the needle bar height 7-6.Adjusting the needle and feed mechanism timing 7-7.Adjusting the needle and rotary hook timing 7-8.Adjusting the rotary hook lubrication amount 8. TROUBLESHOOTING 8-1.Sewing Page Page Page 8-2.Error code displays Page Page Page 9. 7-SEGMENTDISPLAY INSTRUCTION MANUAL