Brother S-7000DD 4-4.Setting basic functions, 4-4-1.Changing the needle stop position, Updn, Corr, SLoW, trdi, LAMP

4. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

4-4. Setting basic functions

If you turn on the power switch while pressing the thread trimming disable/F1 key, you can then make the following settings.

Setting item	Four columns	Initial value	Reference item
	display
Needle stop position	Updn	Needle down	Refer to”4-4-1”.
		stop
Correction	Corr	None	Refer to”4-4-2”.
Slow start	SLoW	None	Setting can be carried out by pressing the
			slow start/F2 key.
Thread trimming disable	trdi	None	Setting can be carried out by pressing the
			thread trimming/F1 key.
Thread wiping	WiP	Enabled	Refer to”4-4-3”.
Needle tip illumination lamp brightness	LAMP	Fully	Refer to the Service Manual.
adjustment		illuminated

4-4-1. Changing the needle stop position

This sets whether the needle bar stops in the needle up stop position or the needle down stop position when the treadle is returned to the neutral position and sewing stops.

1	Activating setting mode
		(Setting item)
	(While pressing the thread trimming disable/F1 key, turn on the
	power switch.)		0517D
2	Setting the needle up stop and needle down stop positions	・ When the D	key is pressed, the “UP”
		display will appear.
	(Setting value)	・ When the C	key is pressed, the “dn”
		display will appear.
		… Needle up stop
		… Needle down stop
		NOTE:
		If the SEL key (1) is pressed once more,
		the ABCD indicator will switch off and the
		display will return to the setting item.
			0518D
3	(Setting item)	The setting will be stored and the display will
		return to the setting item.
			0519D
4		Setting mode will be exited and normal
		operation will be possible.
			0520D

21 S-7000DD