
7. STANDARD ADJUSTMENTS
7-2. Adjusting the presser foot height
The standard height of the presser foot (1) is 6 mm when the presser foot (1) is raised by means of the lifting lever (2).
1. Loosen the nut (3) of the adjustment screw (4), and then turn the adjustment screw (4) so that there is no pressure applied to the presser foot.
2. Raise the lifting lever (2). The presser foot (1) will also rise.
3. Remove the oil cap (5).
4. Loosen the bolt (6) and then move the presser bar (7) up or down until the presser foot (1) is at the standard height of 6 mm.
5. Tighten the bolt (6).
6. Replace the oil cap (5).
7. Adjust the presser foot pressure using the adjustment screw (4), and then tighten the nut (3).
NOTE:
After adjusting, check that the needle moves down into the center of the groove in the presser foot.
Needle
0534D
29 |