[2] Notes on safety

DANGER

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before opening the cover of the control box. Touching areas where high voltages are present can result in severe injury.

WARNING

Do not allow any liquids to get onto this sewing machine, otherwise fire, electric shocks or operating problems may occur.

If any liquid gets inside the sewing machine (machine head or control box), immediately turn off the power and disconnect the power plug from the electrical outlet, and then contact the place of purchase or a qualified technician.

CAUTION

Environmental requirements

Use the sewing machine in an area which is free

The ambient temperature should be within the

from sources of strong electrical noise such as

range of 5°C to 35°C during use.

electrical line noise or static electric noise.

Temperatures which are lower or higher than this

Sources of strong electrical noise may cause

may cause problems with correct operation.

problems with correct operation.

The relative humidity should be within the range of

Any fluctuations in the power supply voltage

45% to 85% during use, and no dew formation

should be within ±10% of the rated voltage for the

should occur in any devices.

machine.

Excessively dry or humid environments and dew

Voltage fluctuations which are greater than this

formation may cause problems with correct

may cause problems with correct operation.

operation.

The power supply capacity should be greater than

In the event of an electrical storm, turn off the power

the requirements for the sewing machine's power

and disconnect the power cord from the wall outlet.

consumption.

Lightning may cause problems with correct

Insufficient power supply capacity may cause

operation.

problems with correct operation.

 

Installation

Machine installation should only be carried out by

If using a work table which has casters, the casters

a qualified technician.

 

 

should be secured in such a way so that they

Contact your Brother dealer or a qualified

cannot move.

 

electrician for any electrical work that may need to

Secure the table so that it will not move when tilting

be done.

 

 

 

 

back the machine head. If the table moves, it may

The sewing machine weighs approximately 32 kg

crush your feet or cause other injuries.

 

(70lb). The installation should be carried out by

Use both hands to hold the machine head when

two or more people.

 

 

tilting it back or returning it to its original position. If

Do not connect the power cord until installation is

only one hand is used, the weight of the machine

head may cause your hand to slip, and your hand

complete. The machine may operate if the treadle

may get caught.

is depressed by mistake, which could result in

 

injury.

 

 

 

 

Be sure to wear protective goggles and gloves

Turn off

the

power

switch before inserting

or

when handling the lubricating oil and grease, so that

they do not get into your eyes or onto your skin,

removing

the

plug,

otherwise damage to

the

otherwise inflammation can result.

control box could result.

 

 

Furthermore, do not drink the oil or eat the grease

 

 

 

 

 

Be sure to connect the ground. If the ground

under any circumstances, as they can cause

connection is not secure, you run a high risk of

vomiting and diarrhea.

receiving a serious electric shock, and problems

Keep the oil out of the reach of children.

with correct operation may also occur.

When securing the cords, do not bend the cords excessively or fasten them too hard with staples, otherwise there is the danger that fire or electric shocks could occur.

ii

S-7000DD