————————————————————————————————————————————————————

Saving stitch settings

This machine is preset with the default settings for the stitch width (zigzag width), stitch length, programmed thread-cutting, and automatic reverse/ reinforcement stitching for each stitch. However, if you wish to save specific settings for a stitch so that

they can be used later, press after changing the settings to save the new settings with the selected stitch. This feature can be used only with utility stitches. The settings you saved will not be cleared if the machine is turned off.

■To use a stitch length of 2.0 mm for the straight stitch

aSelect a straight stitch.

bPress .

Memo

￿The default stitch length is 2.5 mm.

cSet the stitch length to 2.0 mm.

dPress .

•To reset the selected stitch patterns to its

default settings, press , and then

press .

Note

￿All stitch settings (stitch width (zigzag width), stitch length, programmed thread- cutting, and automatic reverse/ reinforcement stitching, etc.) are saved, not just the setting that was changed. When the same stitch pattern is selected, the last

settings saved are displayed even if the

 

machine was turned off. If the settings are

2

changed again and

is pressed, or if

 

is pressed to reset the setting to its

default, the new settings are not saved unless

 

 

is pressed another time.

 

Even if

is pressed, the settings for

 

programmed thread-cutting and automatic

 

reverse/reinforcement stitching are saved in

 

the machine.

 

 

 

 

 

 

￿The confirmation message is displayed.

ePress .

￿The next time that the same straight stitch is selected, the stitch length is set to 2.0 mm.

Useful Functions 67