Introduction, Overview | Cabletron Systems 2200 instruction

Introduction

This chapter introduces the 2E253-49R SmartSwitch 2200 device and provides information about how to obtain additional support from Cabletron Systems.

Important Notice

Depending on the ﬁrmware version used in the 2E253-49R, some features described in this document may not be supported. Refer to the Release Notes shipped with the 2E253-49R to determine which features are supported.

1.1OVERVIEW

The 2E253-49R (Figure 1-1) is a standalone device that has 48 10BASE-T switched ports connected through 4 RJ21 front panel connectors, and 1 slot that can support either an optional High Speed Interface Module (HSIM) or a Very High Speed Interface Module (VHSIM). The HSIMs and VHSIMs are available from Cabletron Systems.

Each of the 48 10BASE-T switched ports can operate in either standard or full duplex mode of operation. Full duplex mode is the default mode as determined by auto-negotiation. Full duplex can also be manually conﬁgured.

48 Ports (10 Mbps)

ETHERNET WORKGROUP SWITCH

12	1	24
PWR

RESETCPU

HSIM/VHSIM Slot

4	8	12	16	20	24	28	32	36	40	44	48
3	7	11	15	19	23	27	31	35	39	43	47
2	6	10	14	18	22	26	30	34	38	42	46

2E253-49R COM

System LEDs

COM Port

RESET Button

Receive (RX)

Transmit (TX)

LEDs

2600-01

Figure 1-1 2E253-49R SmartSwitch 2200 Device

Introduction 1-1

Cabletron Systems 2200 manual Introduction, Overview

Models: 2200

Introduction

Important Notice

1.1OVERVIEW

Figure 1-1 2E253-49R SmartSwitch 2200 Device

4	8	12	16	20	24	28	32	36	40	44	48
3	7	11	15	19	23	27	31	35	39	43	47
2	6	10	14	18	22	26	30	34	38	42	46

4	8	12	16	20	24	28	32	36	40	44	48
3	7	11	15	19	23	27	31	35	39	43	47
2	6	10	14	18	22	26	30	34	38	42	46

4	8	12	16	20	24	28	32	36	40	44	48
3	7	11	15	19	23	27	31	35	39	43	47
2	6	10	14	18	22	26	30	34	38	42	46