Screws Chassis Cover Front Panel | Cabletron Systems 2200 instruction

Removing the Chassis Cover

Screws (4)

Chassis Cover

Front Panel

Chassis

Note: If the device was rack mounted, the four screws fastening the cover to the front panel are removed and installed along with the rackmount brackets.

2504-30

Figure B-1 Removing the Chassis Cover

B-4Optional Installations and Mode Switch Bank Settings

Image 56

Cabletron Systems 2200 manual Screws Chassis Cover Front Panel

Contents

2E253-49R SmartSwitch Installation User’s Guide Page Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Page Page Page Cabletron Systems Limited Program License Agreement Viii Declaration of Conformity Page Contents Troubleshooting Figures Tables Structure of this Guide Using this GuideAbout This Guide Related Documents Xvi Document Conventions Document ConventionsPage Introduction Overview Full Duplex Switched Ethernet Connectivity SmartTrunk Standard/Full Duplex Auto-NegotiationRuntime IP Address Discovery Port/VLAN Redirect Functions Remote Monitoring RmonBroadcast Suppression Trafﬁc Rate Limiting Flow Control Garp Switch Operation Switching Options12 802.1 Port Priority Management Lanview Diagnostic LEDs Optional HSIMs and VHSIMsStandards Compatibility Year 2000 Compliance Getting Help FTP Network Requirements 10BASE-T NetworkPage Installation Installing Options Unpacking the Device Installing the Device Tabletop or Shelf Installation Rackmount Installation Guidelines for the Rackmount Installation Attaching the Strain-Relief Bracket Rack Mounting the 2E253-49R Connecting Power Installing the Device in a Rack Connecting to the Network Redundant Primary AC outlets are On separate circuits Connection Using the RJ21 Angle Adapter Completing the Installation Troubleshooting Using Lanview PWR No link Is enabled and there is a Troubleshooting Checklist OFF 2E253, 2H252, 2H253, and 2H258 Local Using the Reset Button Reset ButtonPage Physical Properties Device SpecificationsSpeciﬁcations INPUT/OUTPUT Ports Electrical SpecificationsEnvironmental Requirements COM Port Pinout Assignments Regulatory CompliancePage Optional Installations Mode Switch Bank Settings Required Tools Removing the Chassis Cover To remove the chassis cover, proceed as follows Screws Chassis Cover Front Panel Setting the Mode Switches Switch 6 Forced BootP Simm Upgrade Figure B-3shows the location of the Dram Simm connector Locating SIMMs Installing the Dram Simm Simm Installing Optional Hsim or Vhsim Interface Modules Figure B-5 Hsim and Vhsim Connector LocationsPage Index Numerics Index-2