Cabletron Systems 2200 instruction

Installing Optional HSIM or VHSIM Interface Modules

B.5 INSTALLING OPTIONAL HSIM OR VHSIM INTERFACE MODULES

Figure B-5 shows the location of the two connectors for an optional HSIM or VHSIM. Depending on the HSIM or VHSIM installed, one or both connectors are used.

NOTE

Do not install the optional HSIM or VHSIM without referring to the associated installation guide.

TOP VIEW WITHOUT COVER

Primary

Power

Supply

Redundant

Power

Supply

Optional

HSIM or VHSIM

	Connectors
FRONT PANEL	2600-31

Figure B-5 HSIM and VHSIM Connector Locations

Optional Installations and Mode Switch Bank Settings

B-9

Image 61

Cabletron Systems 2200 Installing Optional Hsim or Vhsim Interface Modules, Figure B-5 Hsim and Vhsim Connector Locations

Contents

2E253-49R SmartSwitch Installation User’s Guide Page Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Page Page Page Cabletron Systems Limited Program License Agreement Viii Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Xvi Related Documents Document Conventions Document ConventionsPage Overview Introduction Connectivity Full Duplex Switched Ethernet Runtime IP Address Discovery Standard/Full Duplex Auto-NegotiationSmartTrunk Broadcast Suppression Remote Monitoring RmonPort/VLAN Redirect Functions Flow Control Trafﬁc Rate Limiting Switching Options Garp Switch Operation12 802.1 Port Priority Management Optional HSIMs and VHSIMs Lanview Diagnostic LEDsStandards Compatibility Year 2000 Compliance FTP Getting Help 10BASE-T Network Network RequirementsPage Installation Unpacking the Device Installing Options Tabletop or Shelf Installation Installing the Device Guidelines for the Rackmount Installation Rackmount Installation Attaching the Strain-Relief Bracket Rack Mounting the 2E253-49R Installing the Device in a Rack Connecting Power Redundant Primary AC outlets are On separate circuits Connecting to the Network Connection Using the RJ21 Angle Adapter Completing the Installation Using Lanview Troubleshooting PWR No link Is enabled and there is a OFF Troubleshooting Checklist 2E253, 2H252, 2H253, and 2H258 Local Reset Button Using the Reset ButtonPage Speciﬁcations Device SpecificationsPhysical Properties Environmental Requirements Electrical SpecificationsINPUT/OUTPUT Ports Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Optional Installations Mode Switch Bank Settings Removing the Chassis Cover To remove the chassis cover, proceed as follows Screws Chassis Cover Front Panel Switch 6 Forced BootP Setting the Mode Switches Simm Upgrade Locating SIMMs Figure B-3shows the location of the Dram Simm connector Simm Installing the Dram Simm Figure B-5 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesPage Numerics Index Index-2