Installation | Cabletron Systems 2200 instruction

3

Installation

Only qualiﬁed personnel should install the 2E253-49R.

NOTE

Read the Release Notes shipped with the device to check for any exceptions to the supported features and operation documented in this guide.

This chapter provides the instructions required to install the 2E253-49R. A Phillips screwdriver is required to install options into the device or install the device into a rack. Follow the order of the sections listed below to correctly install the device.

•Unpacking the Device (Section 3.1)

•Installing Options (Section 3.2)

•Installing the Device (on a shelf or tabletop, or into a standard rack) (Section 3.3)

•Connecting to the Network (Section 3.4)

•Completing the Installation (Section 3.5)

Installation 3-1

Image 31

Cabletron Systems 2200 manual Installation

Contents

2E253-49R SmartSwitch Installation User’s Guide Page Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Page Page Page Cabletron Systems Limited Program License Agreement Viii Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Xvi Related Documents Document Conventions Document ConventionsPage Overview Introduction Connectivity Full Duplex Switched Ethernet Runtime IP Address Discovery Standard/Full Duplex Auto-NegotiationSmartTrunk Broadcast Suppression Remote Monitoring RmonPort/VLAN Redirect Functions Flow Control Trafﬁc Rate Limiting Management Garp Switch OperationSwitching Options 12 802.1 Port Priority Year 2000 Compliance Lanview Diagnostic LEDsOptional HSIMs and VHSIMs Standards Compatibility FTP Getting Help 10BASE-T Network Network RequirementsPage Installation Unpacking the Device Installing Options Tabletop or Shelf Installation Installing the Device Guidelines for the Rackmount Installation Rackmount Installation Attaching the Strain-Relief Bracket Rack Mounting the 2E253-49R Installing the Device in a Rack Connecting Power Redundant Primary AC outlets are On separate circuits Connecting to the Network Connection Using the RJ21 Angle Adapter Completing the Installation Using Lanview Troubleshooting PWR No link Is enabled and there is a OFF Troubleshooting Checklist 2E253, 2H252, 2H253, and 2H258 Local Reset Button Using the Reset ButtonPage Speciﬁcations Device SpecificationsPhysical Properties Environmental Requirements Electrical SpecificationsINPUT/OUTPUT Ports Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Optional Installations Mode Switch Bank Settings Removing the Chassis Cover To remove the chassis cover, proceed as follows Screws Chassis Cover Front Panel Switch 6 Forced BootP Setting the Mode Switches Simm Upgrade Locating SIMMs Figure B-3shows the location of the Dram Simm connector Simm Installing the Dram Simm Figure B-5 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesPage Numerics Index Index-2