SmartCell 6A000/ZX-250 Reference Manual 1-3
Introduction
IP NetMask : 255.255.255.0
IP/ATM Client 3
==============================================================================
Client State : Operational
Client Address : 39:00:00:00:00:00:00:00:00:00:14:15:00:00:00:5A:01:01:7C:00
Server : is local
Server Connection : Established
MTU : 9180
IP Address : 90.1.1.124
Abbreviations

Pay close attention to how switch attributes appear in each section heading. Switch attributes are not case sensitive. If

the heading states BUSStat, you must type busstat and not busstats, because the switch will not recognize the latter .

See the following example:

switch_prompt # show busstats
Command busstats not Valid for Action show
Type Help <command> for help
switch_prompt #
switch_prompt # show busstat
ELANNumber(ALL) :
BUS ELANs
============================================================================
ELAN ELAN000 Statistics
Out Octets : 0
Out Unicast : 0
switch_prompt #

You can, however, abbreviate the switch attribute to the extent that it is unique. For example, instead of typing show

porttrafficcongestion, you can just type show portt. The same can be done with operators. Instead of typing modify,

you can type mod. You should type at least three characters for any operator. For example,

switch_prompt # modify portmode
PortNumber(ALL) :
PortMode(SONET) :
switch_prompt #
switch_prompt # mod portm
PortNumber(ALL) :
PortMode(SONET) :
switch_prompt #

See "Switch Attribute" for an explanation of how the sections are organized.