2-70 SmartCell 6A000/ZX-250 Reference Manual
Console Commands
LECSAddress
Use LECSAddress (LAN emulation configuration server ATM address) to configure addresses on the switch. This
address identifies the LECS on the network that will be contacted for information when LAN emulation is used. While
there can be many switches in a network, there should be only one active LECS, with the LECS address on each switch
being configured to point to that LECS.
Operators
add, delete, modify, show
Parameter
Descriptions
SERVER SVC
XX
Parameter Description Value/Field Size Default
[LECSAddress] ATM address given to the LECS. 13-20 byte hex-based/
Up to 59 characters Registered LECS address
Operator Parameters/Permissions Description
add
lecsaddress [LECSAddress] <lecsaddr>
Administrator
Defines the LECS ATM address to be used by LANE clients.
If a local LECS is running, this address is automatically set to
this LECS. If another LECS is to be used, stop the local LECS
and add the new LECS ATM address. Remember that you can
have only one LECS in an ATM network.
delete
lecsaddress Administrator Removes the LECS ATM address from the switch.
modify
lecsaddress [LECSAddress] <lecsaddr>
Administrator
Modifies the ATM address of the LECS. Enter modify
lecsaddress if the LECS is not on the local switch and you
want to redirect the LECS requests to another switch. To
make your modification permanent between reboots, be sure
to stop the LECS before entering this command.