Cabletron Systems 9032578-05 Monitoring Frame Relay WAN Ports, Frame Relay Port Configuration

Chapter 25: WAN Configuration Guide

Monitoring Frame Relay WAN Ports

Once you have configured your frame relay WAN interface(s), you can use the CLI to monitor status and statistics for your WAN ports. The following table describes the monitoring commands for WAN interfaces, designed to be used in Enable mode:

Display a particular frame relay	frame-relay show service <service name>
service profile
Display all available frame relay	frame-relay show service all
service profiles
Display the last reported frame	frame-relay show stats port <port name>
relay error	last-error
Display active frame relay LMI	frame-relay show stats port <port name>
parameters	lmi
Display MIBII statistics for frame	frame-relay show stats port <port name>
relay WAN ports	mibII
Display a summary of all LMI	frame-relay show stats port <port name>
statistics	summary

Frame Relay Port Configuration

To configure frame relay WAN ports, you must first define the type and location of the WAN interface, optionally “set up” a library of configuration settings, then apply those settings to the desired interface(s). The following examples are designed to give you a small model of the steps necessary for a typical frame relay WAN interface specification.

To define the location and identity of a serial frame relay WAN port located at slot 5, port 1 with a speed rating of 45 million bits per second:

ssr(config)# port set se.5.1 wan-encapsulation frame-relay speed 45000000

To define the location and identity of a High-Speed Serial Interface (HSSI) VC located at slot 4, port 1 with a DLC of 100:

ssr(config)# frame-relay create vc hs.4.1.100

Suppose you wish to set up a service profile called “profile1” that includes the following characteristics:

•Committed burst value of 2 million and excessive burst value of 1 million

•BECN active shaping at 65 frames

SmartSwitch Router User Reference Manual 343