Cabletron Systems 9032578-05 manual Ssr# ip-policy show policy-name p1

Chapter 15: IP Policy-Based Forwarding Configuration Guide

For example, to display information about an active IP policy called “p1”, enter the following command in Enable mode:

ssr# ip-policy show policy-name p1

--------------------------------------------------------------------------------

IP Policy name			: p1	1
Applied Interfaces : int1					2
Load Policy			: first available 3
4			5		6	7	8	9		10
ACL		Source IP/Mask			Dest. IP/Mask	SrcPort	DstPort	TOS Prot
---		--------------			-------------	--------- --------- --- ----
prof1		9.1.1.5/32			15.1.1.2	any	any		0	IP
prof2		2.2.2.2/32			anywhere	any	any		0	IP
everything		anywhere			anywhere	any	any		0	IP
						N ext Hop Information
						- -------------------
11	12	13		14	15	16		17	18
Seq	Rule	ACL		Cnt Action		Next Hop		Cnt Last
---	----	--------		--- -----------		--------		--- ----
10	permit prof1			0	Policy Only	11.1.1.2		0	Dwn
20	permit prof2			0	Policy Last	1.1.1.1		0	Dwn
						2.2.2.2		0	Dwn
						3.3.3.3		0	Dwn
999	permit everything			0	Policy Only	drop		N/A N/A
65536 deny		deny		0	N/A	normal fwd		N/A N/A
19

Legend:

1.The name of the IP policy.

2.The interface where the IP policy was applied.

3.The load distribution setting for IP-policy statements that have more than one next- hop gateway; either first available (the default) or round-robin.

4.The names of the profiles (created with an acl statement) associated with this IP policy.

5.The source address and filtering mask of this flow.

6.The destination address and filtering mask of this flow.

7.For TCP or UDP, the number of the source TCP or UDP port.

8.For TCP or UDP, the number of the destination TCP or UDP port.

9.The TOS value in the packet.

10.IP protocol (ICMP, TCP UDP).

216 SmartSwitch Router User Reference Manual