Cabletron Systems 9032578-05 manual Examples of Export Policies, Example 1 Exporting to RIP

Chapter 13: Routing Policy Configuration Guide

Examples of Export Policies

Example 1: Exporting to RIP

Exporting to RIP is controlled by any of protocol, interface or gateway. If more than one is specified, they are processed from most general (protocol) to most specific (gateway).

It is not possible to set metrics for exporting RIP routes into RIP. Attempts to do this are silently ignored.

If no export policy is specified, RIP and interface routes are exported into RIP. If any policy is specified, the defaults are overridden; it is necessary to explicitly specify everything that should be exported.

RIP version 1 assumes that all subnets of the shared network have the same subnet mask so it is only able to propagate subnets of that network. RIP version 2 removes that restriction and is capable of propagating all routes when not sending version 1 compatible updates.

To announce routes which specify a next hop of the loopback interface (i.e. static and internally generated default routes) via RIP, it is necessary to specify the metric at some level in the export policy. Just setting a default metric for RIP is not sufficient. This is a safeguard to verify that the announcement is intended.

For all examples in this section, refer to the configuration shown in Figure 18 on page 181.

The following configuration commands for router R1:

•Determine the IP address for each interface

•Specify the static routes configured on the router

•Determine its RIP configuration

!++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

!Create the various IP interfaces. !++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

interface create ip to-r2 address-netmask 120.190.1.1/16 port et.1.2 interface create ip to-r3 address-netmask 130.1.1.1/16 port et.1.3 interface create ip to-r41 address-netmask 140.1.1.1/24 port et.1.4 interface create ip to-r42 address-netmask 140.1.2.1/24 port et.1.5 interface create ip to-r6 address-netmask 160.1.1.1/16 port et.1.6 interface create ip to-r7 address-netmask 170.1.1.1/16 port et.1.7

!++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

!Configure a default route through 170.1.1.7 !++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

ip add route default gateway 170.1.1.7 !+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

!Configure default routes to the 135.3.0.0 subnets reachable through

!R3.

SmartSwitch Router User Reference Manual 187