Location and Function of Parts

Overview 1 Chapter

1Iris ring

For manual iris control, set the IRIS selector qd to the “M” position, and turn this ring.

2Zoom ring

For direct manual zoom control, set the ZOOM selector 7 to the “MANU.” position, and turn this ring.

3Focus ring

Turn this ring to focus the lens on the subject.

4M (close-up) button

For close-up work, turn the MACRO ring 6 while holding this button down. (See page 91.)

5F.B (flange focal length) adjustment ring and F.B fixing knob

F.B adjustment ring : To adjust the flange focal length, loosen the F.B fixing knob, then turn the ring. (See page 89.)

F.B fixing knob: Fixes the F.B adjustment ring.

6MACRO (close-up) ring

For close-up, turn this ring while holding the M button 4 down. (See page 91.)

7ZOOM selector

This selects the mode of zoom operation. SERVO: power zoom

MANU. (manual): manual zoom

8Zoom remote control connector (8-pin) Connect the optional LO-26 lens remote control unit for remote control of zooming.

9Lens connector (12-pin)

Connect to the LENS connector (qa on page 18) of the Camera Head.

0RET (return) button

This allows you to check the video signal as follows.

When operating with a portable VTR connected via other equipment: when the VTR is in

recording, pressing this button connects the E-E video signal1) from the VTR to the viewfinder.

When operating with a DSR-1/1P or PVV-3/3P

mounted on the camera head: when the VTR is in recording pause mode, press this button to review the last few seconds of the recording in the viewfinder (recording review).

When operating with a CCU-M5/M5P/M7/M7P

Camera Control Unit connected: pressing this button connects the return video signal from the camera control unit to the viewfinder.

When this button is not pressed, the viewfinder displays the video signal captured by the camera.

qa VTR button

When operating with a VTR: this button starts and stops recording, and once more to stop.

When operating with a CCU-M5/M5P/M7/M7P

Camera Control Unit connected: pressing this button connects the return video signal from the camera control unit to the viewfinder.

(Starting and stopping recording is controlled on the VTR.)

qs Instant automatic iris adjustment button

While using manual iris control, press this button to switch temporarily to the automatic iris control setting. The automatic setting is maintained as long as you hold the button down.

qd IRIS selector

This selects the mode of iris operation. (See page 14.) A (automatic): automatic iris

M (manual): manual iris

qf Motorized zoom lever

Use this to carry out a power zoom. Pressing the lever harder increases the zoom speed.

W end: zoom toward wide angle

T end: zoom toward telephoto

..........................................................................................................................................................................................................

1)E-E video signal: “electric-to-electric” video signal. This is the input video signal which has passed through internal electrical circuits, but has not been converted to a magnetic signal.

20 Chapter 1 Overview