DXF-801/801CE Viewfinder

You can switch the scan size of the DXF-801/801CE in accordance with the aspect ratio selected on the camera or camcorder.

1 Chapter

1Eyepiece focusing knob

2Stopper

Microphone holding screw

Microphone holder

Microphone

3LIGHT switch and light

HIGH LOW OFF

LIGHT

4TAKE/TALLY indicator

TALLY

TAKE REC BATT

5 BATT indicator

6REC/TALLY indicators

7 GAIN UP indicator

SHUTTER

GAIN UP

8SHUTTER indicator

Eye cup

9PEAKING control

0CONTRAST control

qa Tally lamp

qs BRIGHT control

qd Eyepiece release catch

qf TALLY switch

qg DISPLAY switch

qh Viewfinder connector

Overview

1Eyepiece focusing knob

Turn this to adjust the viewfinder focus to match your eyesight. (See page 88.)

2Stopper

Lift up when detaching the viewfinder (See page 32).

3LIGHT switch and light

The light lights the lens and the switch controls the light as follows.

HIGH/LOW: Turn the light on and control the brightness.

OFF: Turns the lights off.

4TAKE/TALLY indicator (orange)

When using the ClipLink function while shooting, this indicator lights when the TAKE button (7 on page

17)has been pressed to set a Mark IN point and goes out when a Mark OUT point is set.

5BATT (battery) indicator (red)

This lights when the battery capacity is low.

Note

When using a camera control unit, this indicator flashes when

you operate the controls, but this is not a malfunction.

Chapter 1 Overview 21