4 Release the REV or FWD button when you find the tape location where you wish to continue shooting.

The DSR-1/1P enters recording pause mode.

5 Press the VTR button on the camera head or the lens.

The DSR-1/1P starts recording.

Using the Freeze Mix Function

The freeze mix function superimposes a freeze-frame image of a previously recorded shot on the shooting image displayed on the viewfinder screen.

You can use this function to easily frame a subject within the same framework from a previous shot.

Note

When the camera head is in EZ mode, the freeze mix function is disabled. Release the EZ mode beforehand. (See page 14.)

1 Dock the DSR-1/1P to the camera head and connect a color monitor to the MONITOR OUT connector.

2 Perform steps 2 to 10 from “Basic Procedure for Shooting” (page 43).

3 Play back the tape on which the image to be used for framework alignment has been recorded.

For playback operation, refer to the operating instructions for the DSR-1/1P.

4 Press the MENU/STATUS switch down.

The following indication appears on the screen.

PLAY￿

￿

￿

￿

￿

cFREEZE MIX(ONcv)￿

￿

￿

￿

￿

￿

EXIT MENU (YEScv)

5 Press the UP/ON button when you see the image you want to freeze.

The frozen playback image is displayed, mixed with the shooting image, in monochrome. The indication “FREEZE MIX ON” appears on the screen.

￿

FREEZE MIX ON￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

MIX OFF (YEScv)

To release the freeze mix mode, press the UP/ON button again.

To change the freeze-frame image

Press the DSR-1/1P’s PLAY button.

This returns to the screen shown in step 3 above, and color playback mode begins.

Use the DSR-1/1P’s tape transport buttons to find the desired image and then perform steps 4 and 5 again.

6 Once you have framed your subject, press the UP/ ON button to cancel the freeze function.

7 Find the recording start point or insert a new cassette for recording, then begin recording.

Note

If you use the DSR-1/1P’s tape transport buttons during back space editing, the back space editing mode will be stopped. When you were using the ClipLink function when shooting, If you simply restart the recording you will lose any ClipLink data that was recorded. To avoid this, press the DSR-1/1P’s ClipLink CONTINUE button before restarting recording.

For details, see the operating instructions for the DSR-1/1P.

Shooting 3 Chapter

Chapter 3 Shooting 49