Using SetupNavi and SetupLog with the DSR-1/1P

Menus and Indications Screen Viewfinder 4 Chapter

The SetupNavi function records the setup menu and setup files onto a tape, so that the same settings can be called up and used again or copied to another camera. The SetupLog function records a camera settings every few seconds at shooting and displays the recorded data in the viewfinder during playback.

Note on using an RM-M7G Remote Control Unit

When an RM-M7G is connected to the camera head, you cannot use the SetupNavi function.

To make it possible to use the function, power OFF the camera head after disconnecting the RM-M7G, then power ON the camera head again.

Setting up the Camera UsingData Recorded on Tape

The procedure to replace camera’s menu settings with settings recorded onto video tape is described here.

1 Connect the DSR-1/1P and insert the cassette onto which the data was recorded. Set the SETUP switch to FILE, then set the POWER switch to ON while holding down the UP/ON button.

Advanced menu page 1 appears.

2 Repeatedly press down on the MENU/STATUS switch until advanced menu 14 appears.

For details of menu operation, see “Advanced Menu Operations” (page 64).

”NO TAPE” is displayed if you neglected to load a cassette.

3 Press the UP/ON button to call up the data recorded on the tape. (Press the DOWN/OFF button to cancel).

The display changes as follows and the call up operation begins.

Name of data being called up

To abort the call up operation while in progress

Press the DOWN/OFF button.

The following display appears.

4 Press the UP/ON button.

After the data has been read, the following display appears.

The previous menu settings are overwritten by the data recorded on the tape.

5 Change the menu settings if necessary.

76 Chapter 4 Viewfinder Screen Indications and Menus