Canon GC-201, GM-1000

CANON Digital Galvano Scanner System GM-1000 Series

Users Manual 1.20

2.2. Controller (GC-201)

Performance and Dimensions

GC-201

Number of control axes 2

Control sampling 100 kHz

Maximum drive current Peak 10 A (each axis)

Interface RS-232C , High-speed serial communication(XY2-100)

Notch filter

Digital notch filter ×2

Digital low-pass filter ×1

Analog notch filter ×2

Weight 350 g

Environmental conditions

Operating temperature and humidity 0 to 50ºC, 90% RH or less (No condensation)

Storage temperature and humidity -20 to 60ºC, 90% RH or less (No condensation)

Note: The above operating temperature and humidity conditions depend on the operating and heat

radiation conditions.

Section names

Heat radiation

frame

Mounting screw

hole (M3 × 4)

Digital board (upper)

Analog board (lower)

IF board

Mounting screw

hole (φ3.5 × 4)

Contents

Main CANON Digital Galvano Scanner System GM-1000 Series GC-201 Users Manual Rev. 1.20 Warning Caution Warning Caution Contents 2.8.1. 2.8.2. RS-232C command input 2.8.3. High-speed serial communication 11.1.1. Page Page Page Page Page Page Page +5V +24V + Page Page Page Page Page Page 2.8. Control Specifications Page 2.8.1. Page Page Page Page 2.8.3. High-speed serial communication Page Page Page Page Page Page COMMAND XY-2 COMMAND FRAME SYNC DSP Sampling Clock Output to MOTOR 20us COMMAND XY-2 COMMAND FRAME SYNC DSP Sampling Clock Output to MOTOR 2.8.4. Status (High-speed Serial Communication STS) Page Page Page A B 3. Software 3.1. Supported PC Environment 3.2. Installation CD 3.3. Control Software Installation Page Page 3.4. Software Start Up Page 3.5. Control Screen Page 4. Operating Procedure 4.1. Controller Start Up Page Page Page Page Page Page Page Page Page Page 4.4. Position Command Input by High-speed Serial Communication 5. Monitor Output and Digital Input Functions 5.1. Connector Pin Assignment Page Page Page 5.2. Analog Monitor Output Selecting Note: 5.3. Digital Input-Output Function 6. Other - Operation Setting 6.1. Setting Controller Start Up Mode Page 6.2. Controller LED Display Page 6.3. Operation that Synchronizes with External Trigger Signal input (Raster Scan) FPGA 3.3V-TTL 7. Tuning 7.1. Tuning 7.2. Frequency response (FFT) Measurement Page Page Page 7.3. Auto Tuning Page Page Page 7.4. X and Y Axis Matching Page Page Page Page Page Page Page 8. Commands 8.1. List of Commands Page 8.2. Command Details Page Page Page Page Page Page Page Page Page Page 9. Parameters 9.1. List of Parameters Page 9.2. Parameter Details Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page 9.3. Modifying Parameters 9.5. Saving a Parameter File 10. Safety Functions 10.1. Safety Functions CANON Digital Galvano Scanner System GM-1000 Series Users Manual 1.20 130 10.2. Errors Priority: High or CANON Digital Galvano Scanner System GM-1000 Series Users Manual 1.20 131 Priority: Low 11. Appendix 11.1. Firmware Update 11.1.1. Page Page Page 11.2. Parameter Changes from the Number of Encoder Divisions Page Page