Message |
| Action | |
“The remaining level of the following ink | The remaining ink level cannot be correctly detected. | ||
cannot be correctly detected. Replace | Replace the ink tank and close the Scanning Unit (Printer Cover). | ||
the ink tank.” | Printing with an ink tank that was once empty may damage the machine. | ||
U130 | |||
If you want to continue printing in this condition, you need to release the function | |||
| |||
| for detecting the remaining ink level. Press and hold the Stop/Reset button for | ||
| at least 5 seconds, and then release it. | ||
| * With this operation, releasing the function for detecting the remaining ink | ||
| level is memorized. Please be advised that Canon shall not be liable for any | ||
| machine malfunction or damage caused by refilled ink tanks. | ||
| See “Replacing an Ink Tank” on page 50. | ||
“The following ink tank cannot be | z The ink tank is not compatible with this machine. (The lamp on the ink tank is | ||
recognized.” | off.) |
| |
U140 | Install an appropriate ink tank. | ||
U150 | See “Replacing an Ink Tank” on page 50. | ||
| z An Ink tank error has occurred. (The lamp on the ink tank is off.) | ||
| Replace the ink tank. | ||
| See “Replacing an Ink Tank” on page 50. | ||
“**** | Turn off the machine, and unplug the power cord of the machine from the power | ||
Error code” | supply. After a while, plug the power cord of the machine back in, and then turn | ||
| on the machine. If the same error occurs, contact a Canon service | ||
| representative. |
| |
“Scanner is not operating correctly.” | Turn off the machine, and unplug the power cord of the machine from the power | ||
| supply. After a while, plug the power cord of the machine back in, and then turn | ||
| on the machine. If the same error occurs, contact a Canon service | ||
| representative. |
| |
“Release the scanner lock switch and | The Scanner Lock Switch is not released. Slide the Scanner Lock Switch to the | ||
turn the power off and back on.” | release position | and press the ON/OFF button to turn the machine off. | |
| Then, turn the power back on. | ||
| If this error still remains, contact a Canon service representative. | ||
“The card is currently | The Card Slot is set to Read/write mode. | ||
Set to | You cannot print in this mode. After writing on the memory card, set to Read- | ||
performing operation.” | only mode. |
| |
| LCD Cannot Be Seen At All |
| ||
|
|
| |
Cause |
| Action | |
Cannot see the display on the LCD.
zIf the POWER lamp is off
The machine is not powered on. Connect the power cord and press the ON/ OFF button. The machine will power on and the LCD will display a message.
zIf the POWER lamp is lit
The LCD may be in the
74Troubleshooting