Carrier PCV015-060 specifications Deluxe D

13

AL	— Alarm Relay Contacts
BM	— Blower Motor
BMC	— Blower Motor Capacitor
BR	— Blower Relay
CAP	— Compressor Capacitor
CB	— Circuit Breaker

CC— Compressor Contactor

CO	— Sensor, Condensate Overflow
FP1	— Sensor, Low Temperature Protection Water Coil
FP2	— Sensor, Low Temperature Protection Air Coil
HP	— High-Pressure Switch
HPWS	— High-Pressure Water Switch
JW1	— Clippable Field Selection Jumper
*Optional.

Deluxe D

LEGEND

LOC	— Loss of Charge Pressure Switch
MV	— Motorized Valve
MVES	— Motorized Valve End Switch
NEC	— National Electrical Code
P1	— Field Wiring Terminal Block
PB	— Power Block
RVS	— Reversing Valve Solenoid
TRANS	— Transformer
TXV	— Thermostatic Expansion Valve
	Field Line Voltage Wiring
	Field Low Voltage Wiring
	Printed Circuit Trace
	Optional Wiring

Relay/Contactor Coil

Condensate Pan

Solenoid Coil

Thermistor

Ground

Wire Nut

NOTES:

1.Compressor thermally protected internally.

2.All wiring to the unit must comply with NEC and local codes.

3.Transformer is wired to 460-v BLK/RED lead for 460-3-60 units or 575-v GRY lead for 575-3-60 units. Transformer is energy limiting or may have circuit breaker.

4.FP1 thermistor provides low temperature protection for water. When using antifreeze solutions, cut JW3 jumper.

5.Refer to microprocessor control, LON, or thermostat installation instruc- tions for wiring to the unit. Wire “Y” from thermostat to “Y1” Deluxe D when motorized valve is not used. Thermostat wiring must be Class 1 and voltage rating equal to or greater than unit supply voltage. Heat/cool thermostats not compatible with motorized water valve.

6.24-v alarm signal shown. For dry alarm contact, cut JW4 jumper and dry contact will be available between AL1 and AL2.

7.Transformer secondary ground via green wire with yellow stripe from “C” terminal to control box.

8.Blower motor is factory wired for medium and high speeds. For any other combination of speeds, attach black wire to the higher of the two desired speed taps at the motor. Attach the blue wire to the lower of the two desired speed taps.

9.Blower motor is factory wired for high and low speeds. No other combi- nation of speeds is available.

10.The 460-v units using an internal secondary pump will require a neutral wire from the supply side in order to feed the accessory with 265-v.

Fig. 15 — 50PCH,PCV Units with Deluxe D Controller, Three-Phase (460 V)