Saving Keyboard Setups to Registration Memory

To save a setup to registration memory

1.Configure the tone, rhythm, and other settings you want to include in the setup.

2.Press the C-8 (BANK) button to select the bank you want.

•Each press of the C-8 (BANK) button cycles through the bank numbers.

Bank 2 selected

•While the “BANK” screen is displayed after pressing the C-8 (BANK) button, use the dial or R-14(–, +) buttons to select the bank you want.

•If you do not perform any operation for a few seconds, the display will return to previous screen automatically.

3.While holding down the C-13 (STORE) button, press a button from C-9 (1) to C-12 (4) to select an area.

•This will save the settings you configured in step 1 into the applicable setup.

•If there is anything already stored in the setup, it will be replaced (deleted) with the new setup.

Registered as Setup 2-1

•The message “Please Wait” will remain on the display while a data save operation is in progress. Do not perform any other operation while it is displayed. Turning off the Digital Keyboard or removing the memory card can cause Digital Keyboard data to be deleted or become corrupted. It also can cause the Digital Keyboard to fail to turn on when the L-1 (POWER) button is pressed. If this happens, refer to “Troubleshooting” (page E-114).

To recall a setup from registration memory

1.Press the C-8 (BANK) button to select the bank that contains the setup you want to recall.

2.Use buttons C-9 (1) to C-12 (4) to select the area that contains the setup you want to recall.

•This will recall the registration memory setup and automatically configure the Digital Keyboard settings accordingly.

Setup 6-1 recalled

•Notes currently being sounded by the keyboard may stop if you recall a setup that causes a change in octave shift (page E-18). To keep this from happening, either select a setup that does not cause a change in the octave shift setting, or hold down the pedal (which will cause notes currently being played to be sustained).

E-63