Using the Song Sequencer

Editing a Track

The following operations are supported during track (system track, Tracks 01 through 16) editing.

Clearing a single track

Copying one track to another track (Tracks 01 through 16 only)

Combining two tracks into a single track (Tracks 01 through 16 only)

To start a track editor operation

1.Press the C-3 (SONG SEQUENCER) button to enter the song sequencer mode.

2.While holding down the R-13 (FUNCTION) button, press the C-3 (EDIT) button to display the editor menu.

3.Use the R-17 (t, y) button to move the 0to “TrackEdit” and then press the R-16 (ENTER) button.

This displays the track editor menu shown below.

To clear a single track

1.Perform the procedure under “To start a track editor operation” on page E-79 to display the track editor menu.

2.Press the R-16 (ENTER) button.

This causes the “Clear Track” screen to appear.

3.Use the dial or R-17 (u, i) buttons to specify the track you want to clear.

A black box ( ) above a track number in the level meter indicates that there is already data recorded in that track.

You also can select a track using the dial or R-14(–, +) buttons.

4.Press the R-16 (ENTER) button.

5.In response to the “Sure?” message that appears, press the R-14 (YES) button to clear or the R-14 (NO) button to cancel.

E-79