Selecting and Playing a Tone

MASTER CONTROL

To turn on Digital Piano Power

1. After ensuring that the  (POWER) button is in the off position, connect the AC adaptor to the Digital Piano.

Left Side

Off position

On position

 button

•For information about connecting the AC adaptor, see “Power Outlet” (page E-8).

2.Rotate the (VOLUME) knob towards MIN to set the volume to a low level.

3.Connect headphones or other devices to the Digital Piano as necessary (see “Connections” on page E-9).

4.Press the  (POWER) button to turn on the Digital Piano.

•The Digital Piano display screen will appear as shown below, which indicates that it is ready to play (using initial power on default settings).

•To turn off the Digital Piano, press the  (POWER) button again.

IMPORTANT!

•Normally, turning power off and then back on again will return the Digital Piano to its initial power on default settings. If you perform the backup operation (page E-40), turning power back on again will restore the backed up settings. Perform a backup (page E-40) or registration operation (page E-34) to save the keyboard setup if you need to restore it later.

Listening to Demo Tunes

1. While holding down the (PART) button, press the (PLAY/STOP) button.

•This starts demo tune play.

•The Digital Piano has a total of four demo tunes. You can use the  buttons to jump the beginning of the

previous (q) or next (w) demo tune. You can use the Tone Group buttons ( to ) to select a specific demo tune.

•You can play along on the keyboard with demo tune play. Note, however, that you cannot change the tone assigned to the keyboard. Only the key operations described above are supported.

2.To stop demo tune playback, press the (PLAY/STOP) button again.

Selecting a Tone

Your Digital Piano comes with 250 tones (which include 10 drum sets) built in. Tones are divided into the eight tone groups shown below.

Use the following procedure to select a single tone that is applied across the entire keyboard.

To select a tone

1. Use the “Tone List” (page E-57) to look up the group and the number of the tone you want to select.

2. Check to make sure that the lamp above the  (MASTER CONTROL) button is lit.

•If it is unlit, press the  (MASTER CONTROL) button to light it.

3.Check to make sure that the both the  (LAYER) and  (SPLIT) button lamps are unlit.

•If they are lit, press the  (LAYER) and/or  (SPLIT) buttons to turn off both lamps.

4.If the (UPPER 1) button lamp is unlit, press the (UPPER 1) button so its lamp is lit.

English

E-11